Lágur hleðslutæki

Fliegl TPS 118 Bau Standard

Further information
Chassis central axle trailer
Welded fine-grained steel construction
5 pairs of lashing eyes bolted to the outside of the floor/outer frame, 3 tons each
2 pairs of lashing eyes additionally bolted to the floor, 5 tons each in the corners
Gear support foot at the front
Folding rear support
2 wheel chocks with holder
Galvanized steel underride guard
Rear spray flaps across the entire width
Quarter-shell mudguards
Towing device central axle trailer
Towbar with tested 40 mm towing eye
Drawbar height adjustable via spindle, max. adjustment range 250 mm
Axles + suspension
GFA or BPW drum brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation)
Wheels and tires
235 / 75 R 17,5
manufacturer's choice
Factory silver steel rims
Bdedji Riv Topfx Adpsk
Brake system
2-line compressed air brake system
Hand spindle parking brake
Integral air reservoir
2 non-interchangeable coupling heads at the front, with connecting cables to the motor vehicle,
ABS and ALB, with ABS plug at the front, with connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin interchangeable plugs at the front, with connecting cable,
Floor
Steel/ checker plate floor for high point load capacity
Note: Slight floor corrugation possible due to welding distortion!
Platform length approx. 5,200 mm
Front wall / front corner stanchions
25 mm aluminum hollow profile, 320 mm high, steel corner stanchions in volume design
Drop sides
25 mm hollow aluminum profile, 320 mm high, hinged and removable, subdivided with 1 pair of plug-in middle stanchions
Rear wall / rear corner stanchions
1 pair of steel stanchions attached to the frame and with bracket for locking the drive-on ramps, drive-in width approx. 2,430 mm
Drive-on ramps
2 steel ramps 3 100 mm long, 510 mm wide, divided lengthwise, can be moved sidewayswith grab handle on the ramps
covered with wood
With gas pressure jack for one-man operation
Operating instructions
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Country of registration: Germany
with Dekra approval and expert opinion (according to §13 EG - FGV)
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear
Paint finish
Frame DB 7350 nova gray 10-year warranty against rusting through
Front wall/side wall anodized aluminium Centre stanchion DB 7350 nova grey
Hot-dip galvanized drive-on ramps
Attention: Archive pictures!

Þessi auglýsing var sjálfvirkt þýdd. Villa í þýðingu gæti verið til staðar.