Lágur hleðslutæki

Fliegl ZTS 200

Further information
Chassis low loader trailer
Welded steel construction
Turntable with strong ball bearing slewing ring, storage box embedded in turntable front end
Folding rear support
Wheel chocks with holder
Aluminum side bumpers
Rear spray flaps across the entire width
Quarter-shell mudguards in front of 1st axle
Spare wheel holder for 1 electric wheel, with wheel mounting kit
Spare wheel, same make as basic tires, steel rim
Plastic tool box, with shelf, w=620/h=360/t=440 mm, lockable with a padlock. (lock not included in scope of delivery)
Low loader lashing eyes
3 pairs of lashing points, each 10 tons, integrated in the floor at the front 6 pairs of lashing mushrooms at the top and sides, each 10 tons, embedded in the outer frame 1 x according to the rest of the neck area, distributed between them, spacing not greater than 1200 mm 1 x rear bevel
5 pairs of ring lashing eyes embedded in the outer frame, 5 tons each (can be converted to stake pockets)
Trailer drawbar Turntable
Drawbar with tested 40 mm drawbar eye
Axles + suspension
SAF drum brake axles
Axle/chassis laser-measured Reduction of tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings
Wheels and tires
235 / 75 R 17,5
at the manufacturer's choice
Twin steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-applied parking brake
2 non-interchangeable clutch heads at the front, with connecting cables to the motor vehicle,
ABS and ALB, with ABS plug at the front, with connecting cableVoltage converter for 12/24 volt operationNote! A 7-pin 12 volt socket is required on the tractor/tractor! (Required in conjunction with electrical voltage converter!)
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 volt, multi-chamber lights, amber LED lighting on the side
Hedpei Ri Nxefx Adksnu
2 white/red rear lane departure lights
2 white position lights at the front
Additional LED work light(s) at the rear, switched via reversing light
2 x 7-pin interchangeable plugs at the front, with connecting cable1 x 7-pin agricultural plugVoltage converter 12/24 volt (only for electrics, not for ABS/EBS)
Floor
Front area steel floor,
then with 70 mm softwood floor, steel/ checker plate flooring in the wheel housing area
Rear slope with 70 mm softwood floor
Low loading area incl. rear slope 8 200 mm
Drive-on ramps
Steel ramps 2,800 mm long, 750 mm wide, can be moved sideways
covered with wood
with spring lift support
Operating instructions
A special permit is required for axle loads of 10,000 kg. The permit must be applied for individually in each federal state; the legislator does not have to give an approval for 20 t GG. Customer risk.
Country of registration / plates
Country of registration: Germany
with Dekra approval and expert opinion (according to §13 EG - FGV)
24/7 service hotline
Prepared for two-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red on the rear
Paint finish
Frame DB 7350 nova gray10-year warranty against rusting through
Drawbar Galvanized or black, manufacturer's choice
Drive-on ramps Hot-dip galvanized

Attention: Archive pictures!

Þessi auglýsing var sjálfvirkt þýdd. Villa í þýðingu gæti verið til staðar.