Viðvinnslustöð fyrir tré

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Only 110 operating hours!

Equipment and technical data:

Travel ranges:

- X = 1800 mm
- Y = 900 mm
- Z = 80 mm

Made from 18 mm Koskisen panels

Milling bed made of 19 mm MDF as sacrificial plate with guide rails and T-slot nuts for clamping.

Chassis with reinforcements, filled with polymer concrete, designed for transport by pallet truck or forklift.

Mechanical set consisting of profile rails including linear guides and ball screws (2010 and 1605) for all axes.

Shaft couplings and high-performance grease for lubricating the carriages; also includes energy chains with connection sets.

Control set comprised of a Triple Beast controller for controlling 3 axes, with Ethernet interface.

Leadshine drive for the fourth motor. Four stepper motors, 5.0A, 3Nm each with motor cables, as well as a 48V 6.7A switching power supply, LED board for breakout board, ribbon cable and proximity sensors; small parts such as wire leads, ferrules, control cables, heat shrink tubing, and cable lugs. Fully pre-installed in an aluminum enclosure including electrical kit and emergency stop.

- 21.5 inch built-in monitor, including mini PC with Windows 7, Rhino 5.0 CAD software, Estlcam G-code generator, Beamicon2 control software, as well as mouse and keyboard, all pre-installed in an ergonomic console.

Tool length sensor for determining tool length and adjusting the active reference point.
Iodpszk Npgefx Akxjid

Special equipment:

- High-frequency spindle with 2.2 kW, including clamping nut, frequency inverter, line filter, brake resistor, and collet set.

- PC with 8 GB RAM and AMD processor

- Rhino 5.0 CAD software for creating both simple 2D data and 3D solids

Availability: short-term

Location: Flörsheim

Þessi auglýsing var sjálfvirkt þýdd. Villa í þýðingu gæti verið til staðar.