Handvirk álhringlaga sag
UK 350 M
Handvirk álhringlaga sag
UK 350 M
EXW föst verð aukaskattur bætist við
2.542 EUR
framleiðsluár
2024
Ástand
Nýtt
Staðsetning
Bopfingen 

Myndir sýna
Sýna kort
Upplýsingar um vélina
Verð og staðsetning
EXW föst verð aukaskattur bætist við
2.542 EUR
- Staðsetning:
- Gewerbehof 27, 73441 Bopfingen, DE
Hringdu
Tilboðsupplýsingar
- Auglýsingarauðkenni:
- A7451933
- uppfærsla:
- síðast þann 26.09.2024
Lýsing
Aluminum circular saw UK 350 M, manual (MG TL-350-M)
The UK 350 M is a manual table saw with simple, safe operation! With this machine
double miter cuts up to 45° right and left are possible. The miter adjustment is done here by turning the stop jaw. The UK 350 M has a compact design with clear operation. The saw cut is made manually from below into the material to be processed. The material is stretched manually. Fixed protection from the cutting area.
equipment
Compact, closed design with clear operation
Hodjidqk Sjpfx Adkonu
Manual clamping device
Fixed protection from the cutting area
Saw blade ø 350 mm
workflow
1) Setting the cutting angle
2) Loading the material
3) manual clamping of the material
4) Press the start button to start the saw blade
5) the saw cut must be carried out manually with a hand lever
6) after the end of the cut, the machine is switched off!
without base (optionally available) !
It is always possible for you to inspect the desired system in our production/demonstration hall.
Please do not hesitate to contact us.
The UK 350 M is a manual table saw with simple, safe operation! With this machine
double miter cuts up to 45° right and left are possible. The miter adjustment is done here by turning the stop jaw. The UK 350 M has a compact design with clear operation. The saw cut is made manually from below into the material to be processed. The material is stretched manually. Fixed protection from the cutting area.
equipment
Compact, closed design with clear operation
Hodjidqk Sjpfx Adkonu
Manual clamping device
Fixed protection from the cutting area
Saw blade ø 350 mm
workflow
1) Setting the cutting angle
2) Loading the material
3) manual clamping of the material
4) Press the start button to start the saw blade
5) the saw cut must be carried out manually with a hand lever
6) after the end of the cut, the machine is switched off!
without base (optionally available) !
It is always possible for you to inspect the desired system in our production/demonstration hall.
Please do not hesitate to contact us.
Bjóðandi
Athugasemd: Skráðu þig ókeypis eða skráðu þig inn, til að fá aðgang að öllum upplýsingum.
Skráð frá: 2017
Senda fyrirspurn
Sími & Fax
+49 7362 ... auglýsingar
Auglýsingunni þinni hefur verið eytt með góðum árangri
Villa kom upp